Skull mask with movable jaw
3D印刷

A skull mask with moving jaw for cosplay, photo shoots or for fun. The mechanism is driven by the movement of the jaw. When you open your mouth, the mask will also open. For the movement mechanism, you will need 6 screws (3 screws on each side) and 2 springs (one on each side). The holes for the screws must be made in the Meshmixer, any slicer or after printing (as you like). This was done so that you could choose the necessary diameter for your screws yourself. But you can write to me and I will make the necessary holes in the mask.

The dimensions of the mask: X-223.5 mm; Y-202.9 m; Z-229.28 mm. If you have any problems, you can always write to me.

Recomended 3D printing settings:

Layer: 0.2mm
Fill: 15-25%